Zanussi ZDF22002XA Manuel d'utilisateur

GETTING STARTED?EASY.User ManualZDF22002WAZDF22002XAEN User ManualDishwasher

CAUTION!Water and salt can come out of the salt container during filling. To prevent corrosion, start a programmeimmediately after filling the salt co

ADDING MULTI-TABLETS212030• Do not fill the salt container and the rinse aid dispenser.• Set the rinse aid dispenser to the lowest position.PROGRAMME

1. Open the water tap and close the door.2. Select a programme.3. Press .OPTION DELAYWith this option you can postpone the start of a programme by 3

AT THE END OF THE PROGRAMME5 minThe indicator is on. After 5 minutes of non-use, the appliance enters standby mode and all theindicators are off. It

• Detergent tablets do not fully dissolve with shortprogrammes. To prevent detergent residues onthe tableware, we recommend that you use thetablets wi

Problem and alarm code Possible cause and solutionYou cannot activate the appliance. • Make sure that the mains plug is connected to themains socket.•

Problem and alarm code Possible cause and solutionThe appliance trips the circuit-beaker. • The amperage is insufficient to supply simultaneous-ly all

Problem Possible cause and solutionThe interior of the appliance iswet.• This is not a defect of the appliance. it is caused by the hu-midity in the a

CLEANING THE FILTERSBAC• Make sure that there are no residues of food or soil in or around the edge of the sump.• Put back in place the flat filter (C

Capacity Place settings 13Power consumption Left-on mode (W) 5.0Power consumption Off-mode (W) 0.501) Refer to the rating plate for other values.2) If

SAFETY INFORMATIONBefore the installation and use of the appliance, carefully read thesupplied instructions. The manufacturer is not responsible for

WWW.ZANUSSI.COM/SHOP156912730-A-492016

• Put the cutlery in the cutlery basket with the sharp endspointing down or put them in the cutlery drawer in a horizontalposition with the sharp edge

• Do not put flammable products or items that arewet with flammable products in, near or on theappliance.SERVICE• Contact the Authorised Service Centr

EASY START1 2 34561On/off indicator2Programme marker3Indicators4Start button5Delay button6Programme knobINDICATORSEnd indicator.Salt indicator. It is

PROGRAMMESProgrammeDegree of soilType of loadProgramme phasesConsumption values1)Duration(min)Energy(kWh)Water(l) 2)Normal soilCrockery andcutlery• Pr

SETTINGSADJUSTING THE WATER SOFTENER5x6xThe programme marker must be in position.1. Press and hold and simultaneously turn the knob counterclockwi

German degrees(°dH)French degrees(°fH)mmol/l Clarke degreesWater softenerlevel4 - 10 7 - 18 0.7 - 1.8 5 - 12 2<4 <7 <0.7 < 51 2)1) Factory

The programme marker must be in position.1. Press and hold and simultaneously turn the knob counterclockwise until the programme marker is in posi