Zanussi ZDT11001FA Manuel d'utilisateur

ENUser manualDishwasherZDT11001

DA5Put filter (A) to its initialposition. Make sure that itassembles correctly underthe two guides (D).6Assemble filters (B) and(C). Put them into pos

Problem Possible cause Possible solution The filter in the water inlet hose is clog-ged.Clean the filter. The water inlet hose has a kink or abend.M

Problem Possible cause Possible solutionWhitish streaks and stains orbluish layers on glasses anddishes.The released quantity of rinse aid is toomuch.

13

14

15

www.zanussi.com/shop 156957970-A-332011

ContentsSafety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2Product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3Control panel _ _ _ _ _ _ _ _

• Put knives and cutlery with sharp points in the cutlerybasket with the points down or in a horizontal position.• Do not keep the appliance door open

Indicators DescriptionEnd indicator.Salt indicator. This indicator is off while the programme operates.ProgrammesProgramme1)Degree of soilType of load

5. Wait until the programme indicator (A) goes off andthe end indicator comes on (the programme indicator(B) continues to flash).• The acoustic signal

Water hardnessWater softeneradjustmentGermandegrees(°dH)Frenchdegrees(°fH)mmol/l ClarkedegreesManual Electronic11 - 14 19 - 25 1.9 - 2.5 13 - 17 1 34

56Filling the rinse aid dispenserCaution! Only use rinse aid for dishwashers. Otherproducts can cause damage to the appliance.The rinse aid, during th

Using the detergentCaution! Use only detergents for dishwashers.Do not use more than the correct quantity of deter-gent. Refer to the instructions on

Opening the door while the appliance operatesIf you open the door, the appliance stops. When you closethe door, the appliance continues from the point