Zanussi ZDT15002FA Manuel d'utilisateur

ENUser manualDishwasherZDT15002

Dirty filters and clogged spray arms decrease thewashing results.Make a check regularly and, if necessary, clean them.Cleaning the filters1CBA23To rem

Alarm code Problem• The indicator of the set programme flashes continu-ously.• The end indicator flashes 3 times intermittently.The anti-flood device

Problem Possible cause Possible solution The spray arms are clogged. Remove remaining soil with a thin pointedobject. The programme was not applicab

Technical informationDimensions Width / Height / Depth (mm) 596 / 818-898 / 555Electrical connection Refer to the rating plate. Voltage 220-240 V Fr

14

15

www.zanussi.com/shop 15695796 -A-1 052012

ContentsSafety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2Product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3Control panel _ _ _ _ _ _ _ _

– By clients in hotels, motels and other residentialtype environments– Bed and breakfast type environments.Warning! Risk of injury.• Do not change the

Control panel1342CAB51On/off button2Programme buttons3Delay button4Indicators5Function buttonsIIndicators DescriptionSalt indicator. This indicator is

Programme1)Degree of soilType of loadProgramme phases Duration(min)Energy(kWh)Water(l) 4)All Prewash 12 0,1 41) The water pressure and temperature, th

Adjusting the water softenerHard water contains a high quantity of minerals that cancause damage to the appliance and bad washing results.The water so

5. Press function button (AA) again and again to changethe setting. Each time you press function button (AA)you go to the next level.6. Deactivate the

2. Press the on/off button to activate the appliance.Make sure that the appliance is in setting mode. Referto ’SETTING AND STARTING A PROGRAMME’.• If

1. Adjust the water softener to the lowest level.2. Set the rinse aid dispenser to the lowest position.If you stop to use the combi detergent tablets,