Zanussi ZEI3921IBA Manuel d'utilisateur télécharger pdf (Page 9)

Installation

Warning! Refer to the Safety chapters.

Installation

Warning! Read and follow the

instructions carefully. There is a risk of

injury or damage to the appliance.

• Make sure that there is no damage to the ap-

pliance from the transportation. Do not con-

nect a damaged appliance. Speak to the

supplier if necessary.

• Install built-in appliances only after you as-

semble the appliance into correct built-in

units and work surfaces. Make sure that

built-in units and surfaces obey the stand-

ards.

• Obey all orders and standards in force in the

country where you use the appliance (safety

standards, recycling standards, electrical

safety standards etc.)

Warning! Risk of injury from electrical

current.

• The electrical mains terminal is live.

• Make electrical mains terminal free of volt-

age.

• If the fixing bracket is near to the terminal

block, do not let the connection cable come

in contact with the edge of the bracket.

Electrical connection

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains plug (if

applicable).

• The appliance must not be connected with

an extension cable, an adapter or a multiple

socket. There is a risk of fire.

• Do not let the power cable to heat up to a

temperature of more than 90° C. The cable

should be guided by means of clamps fixed

to the side of the cabinet, in order to avoid

any contact with the equipment beneath the

cooktop.

• Make sure that there is access to the mains

plug after the installation.

Electrical Requirements

Permanent electrical installation must agree

with the latest I.E.E. Regulations and local Elec-

tricity Board regulations. For your own safety

the installation must be done by a qualified

electrician (e.g. your local Electricity Board, or a

contractor who is on the roll of the National In-

spection Council for Electrical Installation Con-

tracting [NICEIC]).

The manufacturer refuses to be held re-

sponsible, if these safety measures are not

abided by.

Supply connections:

This hob has to be connected to 230 — 240 V

( 50 Hz) electricity supply.

Before carrying out the connection, make sure:

1. The limiter valve and the electrical system

can take the appliance load (see the rating

plate)

2. The supply system is equipped with an effi-

cient earth connection in compliance with

the current standards and regulations

3. The outlet or omnipolar switch used for

connection is easily accessible with the

appliance installed.

The appliance is supplied with a 3 core flexible

power cable requiring a 13 amp plug fitted with

a 13 amp or 3 amp fuse dependent on the

load. You must purchase and install the plug.

The wires in the cord are coloured as follows:

Green and yellow - Earth

Blue - Neutral

Brown - Live

Replacement of the connection cable

1. Connect the green and yellow (earth) wire

to the terminal which is marked with the

letter 'E', or the earth symbol

, or col-

oured green and yellow.

2. Connect the blue (neutral) wire to the ter-

minal which is marked with the letter 'N' or

coloured blue.

9

www.zanussi.com

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire