Zanussi ZWG6141P Manuel d'utilisateur télécharger pdf (Page 12)

Ink: depending on the type of ink, moisten the

fabric first with acetone

1)

, then with acetic acid;

treat any residual marks on white fabrics with

bleach and then rinse thoroughly.

Tar stains: first treat with stain remover, me-

thylated spirits or benzine, then rub with deter-

gent paste.

Open the door by carefully pulling the

door handle outwards

Load the laundry

Place the laundry in

the drum, one item at

a time, shaking them

out as much as pos-

sible.

Maximum Loads

Recommended loads are indicated in the

«Washing Programmes».

General rules:

• Cotton, linen: drum full but not too tightly

packed;

• Synthetics: drum no more than half full;

• Delicate fabrics and woollens: drum no

more than one third full.

Close the door gently

Warning! Make

sure that any

fabrics were not trap-

ped when closing the

door.

Detergents and additives

Good washing results also depend on the

choice of detergent and use of the correct

quantities to avoid waste and protect the envi-

ronment.

Although biodegradable, detergents contain

substances which, in large quantities, can up-

set the delicate balance of nature.

The choice of detergent will depend on the

type of fabric (delicates, woollens, cottons,

etc.), the colour, washing temperature and de-

gree of soiling.

All commonly available washing machine deter-

gents may be used in this appliance:

• powder detergents for all types of fabric,

• powder detergents for delicate fabrics (40°C

max) and woollens,

• liquid detergents, preferably for low tempera-

ture wash programmes (60°C max) for all

types of fabric, or special for woollens only.

Quantity of detergent to be used

The type and quantity of detergent will depend

on the type of fabric, load size, degree of soiling

and hardness of the water used.

For the quantity of detergent, refer always to

what is written on the product packing.

Use less detergent if:

• you are washing a small load,

• the laundry is lightly soiled,

• large amounts of foam form during washing.

Degrees of water hardness

Water hardness is classified in so-called “de-

grees” of hardness. Information on hardness of

the water in your area can be obtained from the

relevant water supply company, or from your lo-

cal authority.

If the water hardness degree is medium or high

we suggest you to add a water softener follow-

ing always the manufacturer’s instructions.

When the degree of hardness is soft, readjust

the quantity of the detergent.

12

www.zanussi.com

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Commentaires sur ces manuels

Pas de commentaire