Zanussi ZWQ5100 Guide de base télécharger pdf (Page 7)

Drainage filter

Clean the filter located at the base of the appliance regu-

larly :

Water inlet filters

To clean, proceed as follows :

Operating Problems

Numerous checks were carried out on your appliance be-

fore it left the factory. However, should you notice a mal-

function, please refer to the sections below before contact-

ing the after-sales service.

Problems Causes

The washing machine

doesn’t start or doesn’t fill:

• the appliance isn’t plugged in correctly, the electrical installation isn’t working,

there is a power failure,

• the lid of your appliance and the drum shutters aren’t closed firmly,

• the programme start command hasn’t been properly selected,

• the water supply has been cut off, the water inlet tap is closed,

• the water inlet filters are dirty,

•

a red tab appears on the water inlet hose

The appliance fills but emp-

ties straight away:

• the drainage U-piece is fixed too low (see installation section).

The washing machine

doesn’t rinse or doesn’t emp-

ty:

• the drain hose is blocked or bent,

• the drainage filter is obstructed,

• the out of balance detector has been activated : washing is unevenly distributed in

the drum,

• the “Drain” programme or “Night Silence Plus” or “Rinse hold” option have been

selected,

• the height of the drainage U-piece is unsuitable.

www.zanussi.com

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Zanussi ZWQ5100 Guide de base Page 7