Zanussi ZHI60111G Manuel d'utilisateur télécharger pdf (Page 11)

INSTALLING THE COOKER HOOD

Please ensure that when the appliance is

installed it is easily accessible to an

engineer in the event of a breakdown.

All installations must comply with the local

authorities requirements for the discharge of

exhaust air.

Incorrect installation may affect the safety of this

cooker hood.

Installation Requirements

Before installation check the wall to which the

cooker hood is to be tted for electric cables,

water pipes or gas.

If it is necessary to x the hood to a hollow

construction plaster or partition board

structure then it should be sufciently

reinforced to be quite rigid in the area of the

cooker hood mounting brackets, and the

appropriate rawl plugs used for this type of

xing (not supplied).

Ducting

The ducting must be re retardant 100mm (4ins)

in diameter and the length should be no

more than:

3 metres with one 90° bend

2 metres with two 90° bends

Bends of more than 90° will reduce the

efciency of the hood and reduce the airow.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Zanussi ZHI60111G Manuel d'utilisateur Page 11