Zanussi ZCM1000X Manuel d'utilisateur télécharger pdf (Page 22)

PRESSURE TESTING

1. The rapid injector is used as a pressure test point.

2. Connect the pressure gauge to the Rapid injector.

3. Check the supply pressure by turning the Rapid burner on and one other hotplate burner full on and light the

appropriate burner. The pressure should be :-

(i) for natural gas 20mbar.

4. Turn off the taps, disconnect the pressure gauge.

5. Check operation of each hotplate burner.

CHECKING THE HOTPLATE

Fit the burner crowns and caps ensuring that they are correctly seated. Fit the pan support. Check each of the

hotplate burners in turn by turning the hotplate to its full position and holding the knob depressed. As soon as the

burners are lit the knob can be released.

GENERAL NOTE

Instruct the user how to use the appliance and its ignition system. Refer the user to the wording in the inside

cover which gives advice on the safe operation of the appliance.

INSTALLATION INSTRUCTIONS

1 2 ... 17 18 19 20 21 22 23 24

Pas de commentaire

Zanussi ZCM1000X Manuel d'utilisateur Page 22