Zanussi ZLB161X Manuel d'utilisateur télécharger pdf (Page 15)

3. Adjust the adjustment screw (A) with a thin

bladed screwdriver.

A

Change of type of

gas

Adjustment of the

adjustment screw

from natural gas to

liquid gas

fully tighten the ad-

justment screw in

from liquid gas to nat-

ural gas

release the adjust-

ment screw approxi-

mately 1/2 of a turn

4. Attach the gas oven control knob.

5. Put the mains plug into the mains socket.

Warning! Only put the mains plug into the

mains socket when all parts are put back

into their initial position.

6. Light the gas oven burner (see section

„Gas oven cooking - Ignition of the gas

oven burner“).

7. Set the gas oven control knob to 240 and

let the oven heat for 10 minutes minimum.

8. Turn the gas oven control knob from 240

to minimum.

Control the flame. If the flame goes out, do the

procedure from point 1 to point 7 again. There

must be a small regular flame on the gas oven

burner crown.

The manufacturer objects liability if you

do not obey to this safety measures.

Building-in the Appliance

Conditions for Building-in:

• Only set up the appliance in a kitchen or in a

kitchen-dining room.

• Do not set up the appliance in a bath room

or a bedroom.

• You can install the appliance “built-in“ or

“built-under“:

594

2

20

570

590

540

560

50

110

560÷570

560÷570

560÷570

580

580

580

550 min

550 min

550 min

110

240

140

593

550 min

550 min

550 min

4 min

560 ÷570

560 ÷570

560 ÷570

110

593

550 min

550 min

550 min

560 ÷570

4 min

• The related diagrams show the necessary di-

mensions of the oven and the cabinet (in mil-

limetres).

• The dimensions of the built-in cabinet must

be in compliance with the related diagrams.

• There must be a minimum clearance of 4 mm

between the top surface of the appliance

and the inner top of the cabinet.

• When you install the appliance “built-un-

der“ (below a hob), install the hob before the

oven unit.

• The materials must be resistant to a tempera-

ture increase of minimum 60°C above the

ambient temperature.

• There must be a continuous air supply to the

oven to prevent the oven to become too hot.

• The oven cabinet must have a 130 cm²

opening for minimum.

• When you install a hob above the oven, make

different electrical connections for the hob

and for the oven.

Only make extensions with correct cables for

the power supplied.

Make sure that, after the installation, an

engineer can get access to the oven easi-

ly, if repairs or maintenance are necessary.

15

www.zanussi.com

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire