Zanussi ZC650 Manuel d'utilisateur télécharger pdf (Page 20)

19

Flame adjustment

1. Light the burner

2. Turn the knob to minimum level

3. Pull out the knob

4. Unscrew or screw the pin (on the right of

tap axle) until a regular small flame is

obtained. For butane-propane gas,

screw totally the pin clockwise

5. Put in place the knob

6. Turn the knob several times from

maximum to minimum level for verifying the

flame steadiness.

GRILL BURNER

- Loosen the screw fixing the Venturi.

- Move the pipe left or right till getting the

right adjustment

- Tighten the fixing screw.

OVEN LAMP REPLACEMENT

(for the model ZC 501)

Before replacing the lamp take care

that all control knobs be on “off”

position

« ».

Disconnect the appliance; watch that the

oven be cool.

This lamp of 15 W, convection E 14

(230/240V) is a special lamp for “higher”

temperature, up to 300˚C. It is supplied on

order, by your After Sales Service.

The lamp is fixed in back of the oven and is

accessible from inside.

For reaching the lamp:

1. Unscrew the glass lamp protection;

2. Unscrew the lamp;

3. Replace the lamp;

4. Remount the lamp protection

1 2 ... 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire