Zanussi ZGG76534XA Manuel d'utilisateur Page 1

ENZGG76534User ManualHobMA

InstallationWARNING!Refer to Safety chapters.Before the installationBefore you install the hob, write down theinformation bellow from the rating plate

Adjustment of minimum levelTo adjust the minimum level of the burners:1. Light the burner.2. Turn the knob on the minimum position.3. Remove the knob.

min. 55 mmmin. 650 mm700 mmmin. 450 mm30 mm480 mm10 mm86 mm86 mmA3 mmABA) supplied sealB) supplied bracketsCAUTION!Install the appliance only on awork

Other technical dataTOTAL POWER:Gas original: G20 (2H) 20 mbar = 12 kWGas replacement: G30 (3+) 28-30 mbar = 858 g/hG31 (3+) 37 mbar = 843 g/hElectric

Energy efficiency per gas burner(EE gas burner)Left middle - Triple Crown 52.0%Centre rear - Semi-rapid 54.0%Right rear - Rapid 52.0%Centre front - Se

www.zanussi.com 15

www.zanussi.com/shop867315976-A-442014

ContentsSafety information 2Safety instructions 3Product description 5Daily use 6Hints and tips 7Care and cleaning 7Troubleshooting 8Installation 10Te

• Unattended cooking on a hob with fat or oil can be dangerousand may result in fire.• Never try to extinguish a fire with water, but switch off theap

• Before carrying out any operation make surethat the appliance is disconnected from thepower supply.• Make sure that the electrical information onthe

• Do not let cookware to boil dry.• Be careful not to let objects or cookware fallon the appliance. The surface can bedamaged.• Do not activate the co

Control knobSymbol Descriptionno gas supply / off positionSymbol Descriptionignition position / maximumgas supplyminimum gas supplyDaily useWARNING!Re

CAUTION!In the absence of electricity you canignite the burner without electricaldevice; in this case approach theburner with a flame, turn the contro

• Always use cookware with clean bottom.• Scratches or dark stains on the surface haveno effect on how the hob operates.• Use a special cleaner applic

Problem Possible cause Remedy The fuse is released. Make sure that the fuse is thecause of the malfunction. If thefuse releases again and again,conta