Zanussi ZWP581 Manuel d'utilisateur Page 4

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 16
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 3
Dispenser box
Prewash
Wash
Softener (do not fill above the MAX symbol
M
)
How to run a wash cycle?
Using for the first time
Ensure the electrical and water connections com-
ply with the installation instructions.
Remove the polystyrene insert and all other items
inside the drum.
Run an initial wash cycle at 90°C, without any
washing but with detergent to clean the water
tank.
Daily use
Loading washing
Open the lid of the ap-
pliance.
Open the drum by de-
pressing the locking
button A: The two
shutters unlock auto-
matically.
Load the washing,
close the drum and the
lid of your washing machine.
Warning! Before closing the lid of your appliance,
ensure that the drum is properly closed :
When the two shutters are closed,
locking button A released.
Proportioning of detergents
Pour the amount of washing into the washing and pre-
wash
compartments if you have selected the “pre-
wash” option. Pour fabric softener into the compartment
if necessary.
Selection of desired programme
Turn the programme selector to the required programme.
The “Start/Pause”
pushbutton flashes green.
A
If you turn the programme selector to another programme
while a cycle is in progress, the appliance will ignore the
new selected programme. The “Start/Pause
pushbut-
ton flashes red for a few seconds.
Selecting the spin speed
Press the “Spin” button to change the spin speed, if
you want your washing to be spun at a different speed to
the one selected by the appliance. You can also select the
“Rinse hold”
option.
For the maximum spin speeds see "Washing pro-
grammes".
Rinse hold
By selecting this function the water of the last rinse is not
emptied out to prevent the fabrics from creasing.
At the end of the programme, if you have selected the
“Rinse hold”
, you then need to select a “Spin” or
“Drain”
programme to finish the cycle and empty the
water.
Selecting options
You must select the different options after selecting the
programme and before pressing the “Start/Pause”
pushbutton (see “Programmes table”). Press the desired
button(s) : the corresponding lights come on. If pressed
again, the lights go out. If one of the options is not com-
4
Vue de la page 3
1 2 3 4 5 6 7 8 9 ... 15 16

Commentaires sur ces manuels

Pas de commentaire