Zanussi ZC650 Manuel d'utilisateur télécharger pdf (Page 6)

INSTALLATION

For the installer and qualified technicians

It is mandatory that all operations required for the installation and maintenance be

carried out by a competent gas installer and in accordance with existing rules and

regulations.

IMPORTANT

Before installing check that the technical features on the factory label suit to the

gas supplied.

This appliance is not connected to a chimney. It must be installed and connected

in accordance with the rules and regulation and the relevant codes of practice.

Comply with the regulations concerning ventilation.

PLACEMENT

The gas cooker must be installed in a well-ventilated kitchen, so as to comply with

regulation in force. The permanent openings for kitchen ventilation has to be 2 m

above the flooring, but avoid unbearable draught. The necessary air for

combustion is of 2 m

/h/kW (see the factory label)

When the appliance is installed near a furniture watch that the sides be not

inflammable, or they should resist 100

C .

In the build bellow the right placement of the appliance.

2 cm

59 cm

66 cm

CONNECTION TO THE GAS SUPPLY

The gas cooker can be connected to the gas supply on the right side. The gas

inlet on the appliance is a 1/2" gas parallel male type. There are 3 possibilities for

connecting

− rigid pipe with gasket.

− pipe with mechanical end.

− rubber hose pipe

In case of rubber hose pipe screw on the inlet the hose nipple corresponding to

the type of gas supposed to be used interspersing also a gasket.

B A C E

Connection by rubber hose to gas supply has to be done so that it should not pass

behind the cooker.

A – Distributor pipe

B – Nut 1/2"

C – Gasket

D – Hose nipple

E – Elbow

1 2 3 4 5 6 7 8

Pas de commentaire

Zanussi ZC650 Manuel d'utilisateur Page 6