Zanussi ZDT26010FA Manuel d'utilisateur

GETTING STARTED?EASY.User ManualZDT26010FAEN User ManualDishwasher

ADDING SALTBefore first use put one litre of water in the salt container.Water and salt can come out from the salt container when you fill it. Risk of

ADDING MULTI-TABLETS212030• Adjust the water softener to the lowest level.THE AUTO OFF FUNCTIONThis function decreases energy consumption by deactivat

OPTION XTRADRYActivate this option when you want to boost the drying performance. With the use of this option, theduration of some programmes, water c

If you open the door before the activation of AUTO OFF, the appliance is automaticallydeactivated.HINTS AND TIPSGENERALThe following hints will ensure

BEFORE STARTING A PROGRAMMEMake sure that:• The filters are clean and correctly installed.• The cap of the salt container is tight.• The spray arms ar

INTERNAL CLEANING• Carefully clean the appliance, including therubber gasket of the door, with a soft dampcloth.• If you regularly use short duration

Problem and alarm code Possible cause and solutionThe program lasts too long. • If the delayed start option is set, cancel the delay setting or waitfo

Problem Possible cause and solutionThere are whitish streaks or blu-ish layers on glasses and dishes.• The release quantity of rinse aid is too much.

TECHNICAL INFORMATIONDimensions Width / height / depth (mm) 596 / 818 - 898 / 555Electrical connection 1) Voltage (V) 220 - 240Frequency (Hz) 50Water

19

SAFETY INFORMATIONBefore the installation and use of the appliance, carefully read thesupplied instructions. The manufacturer is not responsible for

WWW.ZANUSSI.COM/SHOP156902180-A-502015

• Do not keep the appliance door open without supervision toprevent to fall on it.• Before any maintenance operation, deactivate the applianceand disc

• When you contact the Authorised ServiceCentre, ensure that you have the followinginformation that is available on the rating plate.Model :PNC :Seria

EASY START134 5 6 7 8921On/off button2Display3Programme button (up)4Programme button (down)5Half load button6XtraDry button7Delay button8Cancel button

ProgrammeDegree of soilType of loadProgramme phasesConsumption values1)Duration(min)Energy(kWh)Water(l)P4Quick A30Min5)Fresh soilCrockery andcutlery•

When the appliance is in Programme selection mode it is possible to set a programme.If the control panel does not show this condition, do the Cancel.C

• The indicator continues to flash.• The display shows the current setting: e.g. = level 5.2. Press to change the setting. Each time you press t

– = rinse aid empty notification activated.– = rinse aid empty notification deactivated.2. Press to change the setting.3. Press on/off button to c