Zanussi ZI7280D Manuel d'utilisateur

REFRIGERADORCONGELADORFRIDGE-FREEZERFRIGORÍFICO-CONGELADORZI 7280 D LIBRO DE INSTRUCCIONES INSTRUCTION BOOKLET MANUAL DE INSTRU

23USEStarting-up and temperature regulationInsert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, to be found

24Food refrigerationTo achieve the best results with the refrigerator compartment, you should follow one or two very simple rules:Do not put warm food

25For more thorough cleaning, the top door shelf can be removed by pulling it in the direction of the arrows, then refitting it in position (Fig. 13).U

26DefrostingFrost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal

27MAINTENANCEUnplug the appliance before carrying out any maintenance operation.Periodic cleaningNever use metal objects for cleaning your appliance a

15Warning!The appliance which you have just bought is supplied not only with the instruction manual, but also with a Warranty Card Certificate, on the

16WARNINGSGeneral Safetyª This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with

17CONTENTSInstallation 18ª Location 18ª Cleaning the appliance’s interior 18ª Instructions for total built-in 19ª Door reversibility 19ª Electrical co

18INSTALLATIONIf this refrigerator featuring magnetic door seals is to replace an older appliance having a spring lock on the door or lid, be sure to

19 Instructions for total built-inDoor reversibilityRight-hand openingRemove the pins (P) and (P1).Left-hand openingRemove pins (P) from both sides an

20For appropriate venting, follow indications in Fig. 2.Push appliance into housing until stop strip (A) touches the kitchen unit.If after having carr

21Press in the joint covers between the appliance and the kitchen furniture.Apply covers (B) on joint cover lugs and into hinge holes.Position the run

22Remove the little plates and make the holes with a diam. of 2 mm. Replace the little plates over the runners and screw in the screws provided (3.5x1