Zanussi ZGG35214XA Manuel d'utilisateur Page 8

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 16
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 7
Burner Diameter of
cookware
(mm)
Rapid 180 - 240
Burner Diameter of
cookware
(mm)
Auxiliary 80 - 160
Care and cleaning
WARNING!
Refer to Safety chapters.
General information
Clean the hob after each use.
Always use cookware with clean bottom.
Scratches or dark stains on the surface have
no effect on how the hob operates.
Use a special cleaner applicable for the
surface of the hob.
WARNING!
Do not use knives, scrapers or
similar instruments to clean the
surface of the glass or between the
rims of the burners and the frame (if
applicable).
Wash stainless steel parts with water, and
then dry them with a soft cloth.
Pan supports
The pan supports are not resistant
to washing in a dishwasher. They
must be washed by hand.
1. Remove the pan supports to easily clean
the hob.
Be very careful when you
replace the pan supports to
prevent the hob top from
damage.
2. The enamel coating occasionally can have
rough edges, so be careful when you wash
the pan supports by hand and dry them. If
necessary, remove stubborn stains with a
paste cleaner.
3. After you clean the pan supports, make sure
that they are in correct positions.
4. For the burners to operate correctly make
sure that the arms of the pan supports are
aligned with the centre of the burner.
Cleaning the hob
Remove immediately: melted plastic,
plastic foil, and food with sugar. If not, the
dirt can cause damage to the hob.
Remove when the hob is sufficiently
cool: limescale rings, water rings, fat stains,
shiny metallic discoloration. Clean the hob
with a moist cloth and some detergent. After
cleaning, rub the hob dry with a soft cloth.
To clean the enamelled parts, cap and
crown, wash them with warm soapy water
and dry them carefully before you put them
back.
Cleaning the spark plug
This feature is obtained through a ceramic
ignition candle with a metal electrode. Keep
these components well clean to prevent difficult
lighting and check that the burner crown holes
are not obstructed.
Periodic maintenance
Speak to your local Authorised Service Centre
periodically to check the conditions of the gas
supply pipe and the pressure adjuster, if fitted.
Troubleshooting
WARNING!
Refer to Safety chapters.
8 www.zanussi.com
Vue de la page 7
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire