Zanussi ZOB 641 Manuel d'utilisateur télécharger pdf (Page 11)

Fig. 12

Fig. 11

FO 2159

Securing the oven to the cabinet

- Fit the appliance into the cabinet recess.

- Open teh oven door and secure the oven to the kitchen

cabinet with four wood screws, which fit the holes

provided in the oven frame (Fig.11).

When installing an electric plate hob over the oven, the

hob's electrical connection and the oven's one have to be

carried out separately, for security reasons and to let the

oven be taken off the unit easier, if necessary.

Electrical connection

Before the appliance is connected:

1) check that the main fuse and the domestic installation

can support the load;

2) check that the power supply is properly earthed in

compliance with the current rules;

3) check the socket or the double pole switch used for

the electrical connection can be easily reached with

the appliance built in the forniture unit.

This appliance is supplied without connection cable. A

suitable one must be fitted, in compliance with the

electric supply rate. Only the following cable types must

be used: H07 RN-F, H05 RN-F, H05 RR-F, H05 VV-F, H05

V2V2-F (T90), H05 BB-F (section 3 x 1 mm

). A suitable

plug, able to carry the load specified on the rating

plate, must be fitted to the cable. The plug has to be

fitted in a proper socket.

If connecting the appliance directly to the electric system,

a double pole switch must be installed between the

appliance and the electricity supply, with a minimum gap

of 3 mm. between the switch contacts and of a type

suitable for the required load in compliance with the

current rules. The earth wire must not be interrupted by

the double switch pole.

The connection cable has to be placed in order that, in

each part, it cannot reach a temperature 50 °C higher than

the room temperature.

After the connection is carried out, test the heating

elements for about 3 minutes.

Terminal block

The oven has an easily accessible terminal block, which

is meant to work with an electric single-phase rate of

230 V (Fig. 12).

The manufacturer disclaims any

responsability should all the safety

measures not be carried out.

FO 0039

1 2 ... 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire

Zanussi ZOB 641 Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Four Zanussi ZOB 641