Zanussi ZWT71201WA Manuel d'utilisateur télécharger pdf (Page 26)

Ø 35 mm

14 mm

16-22 mm

22±1,5 mm

416

595-598 mm

Hinges

To mount the hinges drill two holes (dia. 35 mm,

depth 12.5-14 mm depending on the depth of door

furniture) on the inner side of the door.

To fix the hinges to the door use the screws for

wood 1 and 2 supplied with the appliance (see

below).

The distance between the holes hobs fixing centres

must be 416 mm. The distance from upper edge of

the door to the centre of the hole depends on the

adjacent furniture's dimensions.

Door mounting

To mount the door fix the hinges to the appliance

using the M5x15 screws.

Do not remove the screw B !!

The hinges can be adjusted to compensate for

possible uneven thickness of the door.

To align the door perfectly, loosen the screw, adjust

the door and tighten the screw A again.

The appliance is prearranged for a magnetic

closure of the door. To enable a correct operation

of this device, screw the counter-magnet A (steel

disk + rubber ring) into the inner side of the door.

Its position must correspond to the magnet B on

the appliance.

Do not remove the screw C !

If the door has to be opened from left to right, invert

the position of the plates E, the magnet D and the

plate C.

Mount the counter-magnet D and the hinges A as

previously described.

Do not remove the screw B!

1 2 ... 21 22 23 24 25 26 27 28

Pas de commentaire

Zanussi ZWT71201WA Manuel d'utilisateur Page 26