Zanussi ZCG61276XA Manuel d'utilisateur télécharger pdf (Page 22)

GAS BURNERS FOR LPG G30 28-30 mbar

BURNER NORMAL POWER kW REDUCED POWER kW

INJECTOR MARK

1/100 mm

Rapid 3.0 0.72 88

Semi-rapid 2.0 0.43 71

Auxiliary 1.0 0.35 50

Oven 2.25 1.0 71

Grill 2.0 1.5 71

GAS CONNECTION

The gas pipe in the appliance has two endings. You

can connect the gas supply to either one of them.

The pipe that is not used must be clogged with the

pipe closer, which added to the appliance.

Use a fixed connections or use a flexible stainless

steel pipes in compliance with the regulation in

force. If you use flexible metallic pipes, make sure

they do not come in touch with mobile parts and

they are not squeezed.

FLEXIBLE NONMETAL PIPES CONNECTION

If you have an easy access to the connection, you

can use a flexible pipe. The flexible pipe must be

tightly attached by clamps.

In installation always use the pipe holder and the

gasket. The flexible pipe can be applied when:

• it can not get hotter than room temperature,

higher than 30 °C,

• it is not longer than 1500 mm,

• it has no narrowing anywhere,

• it is not twisted or tighten,

• it does not get in touch with sharp edges or

corners,

• it's conditions can be easily checked.

When checking the flexible pipe make sure:

• it does not show cracks, cuts, marks of burnings

on the two ends and on its full length,

• the material is not hardened, but shows its

correct elasticity,

• the fastening clamps are not rusted,

• expired term is not due.

If one or more defects are visible, do not repair the

pipe, but replace it.

WARNING! When installation is

complete, make sure that the seal of

each pipe fitting does not leak. To

check the seal use a soap solution, not

a flame.

The gas supply ramp is on the rear side of the

control panel.

WARNING! Before you connect the

gas, disconnect the appliance from the

electricity supply or switch off the fuse

in the fuse box. Close the primary

valve of the gas supply.

ADJUSTMENT TO DIFFERENT TYPES OF GAS

WARNING! Let only an authorized

person do the adjustment to different

types of gas.

If the appliance is set for liquid gas

you can change it to natural gas, with

the correct injectors.

The gas rate is adjusted to suit.

WARNING! Before you replace the

injectors, make sure that the gas

knobs are in the Off position.

Disconnect the appliance from the

electrical supply. Let the appliance

cool down. There is a risk of injury.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire

Zanussi ZCG61276XA Manuel d'utilisateur Page 22

Commentaires sur ces manuels

Produits connexes et manuels pour Plaques chauffantes Zanussi ZCG61276XA