Zanussi ZWT71201WA Manuel d'utilisateur télécharger pdf (Page 20)

45°

20°

• Screw the hose back

to the machine and

make sure the con-

nection is tight.

• Turn on the water tap.

FROST PRECAUTIONS

If the appliance is installed in an area where the

temperature can be less than 0° C, remove the

remaining water from the inlet hose and the drain

pump.

1. Disconnect the mains plug from the mains

socket.

2. Close the water tap.

3. Place the end of the emergency emptying hose

and that of the inlet hose in a bowl placed on

the floor and let water flow out of the hoses.

4. Set the Drain programme and let it operate until

the end of the cycle.

5. Turn the programme knob to to disconnect

the appliance from the power supply.

6. Screw the water inlet hose back on and re-fit

the emergency emptying hose after having put

the cap on again.

WARNING! Make sure that the

temperature is more than 0 °C before

you use the appliance again.

The manufacturer is not responsible

for damages caused by low

temperatures.

EMERGENCY EMPTYING OUT

If the appliance does not drain the water, proceed

as follows:

1. Disconnect the mains plug from the mains

socket.

2. Close the water tap.

3. If necessary, wait until the water has cooled

down.

4. Place a bowl on the floor and put the end of

the emergency emptying hose into the bowl.

Remove its cap.

The water should drain by gravity into the bowl.

5. When the bowl is full, put the cap back on the

emergency hose.

6. Empty the bowl. Repeat the procedure until

water stops flowing out.

7. Clean the pump if necessary as previously

described.

8. Replace the emergency emptying hose in its

seat after having plugged it.

9. Screw the water inlet hose back on.

TROUBLESHOOTING

WARNING! Refer to Safety chapters.

INTRODUCTION

The appliance does not start or it stops during

operation.

First try to find a solution to the problem (refer to

the table). If the problem persists, contact the

Authorised Service Centre.

With some problems, the acoustic signals

operate and the display shows an alarm

code:

•

- The appliance does not fill with water

properly. Start the appliance again by pressing

Start/Pause button. After 10 seconds the door

will be unlocked.

• - The appliance does not drain the water.

• - The appliance door is open or not

closed correctly. Please check the door!

• - The mains supply is unstable. Wait until

the mains supply is stable.

• - No communication between electronic

elements of the appliance. Switch off and

switch on again. The programme was not

finished properly or the appliance stopped too

early. If the alarm code appears again, contact

the Authorised Service Centre.

WARNING! Deactivate the appliance

before you do the checks.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Zanussi ZWT71201WA Manuel d'utilisateur Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Séchoirs à tambour Zanussi ZWT71201WA