Zanussi ZWD1261 Manuel d'utilisateur télécharger pdf (Page 13)

Child safety lock

This device permits you to leave the appliance unattended

so you do not need to worry that children might be injured

by or cause damage to the appliance. This function re-

mains enabled also when the washing machine is not

working.

There are two different ways to set this option:

1. Before pressing button 7: it will be impossible to

start the machine.

2. After pressing button 7: it will be impossible to

change any other programme or option.

To enable or disable this option press simultaneously for

about 6 seconds buttons 2 and 3 until on the display, the

icon

appears or disappears.

Daily Use

Load the laundry

Open the door by carefully

pulling the door handle

outwards. Place the laun-

dry in the drum, one item

at a time, shaking them

out as much as possible.

Close the door.

Make sure that no laundry

stays between the seal and

the door. There is a risk of

water leakage or damage

to the laundry.

Measure out the detergent and the fabric softener

Pull out the dispenser drawer until it stops. Measure

out the amount of detergent required, pour it into the

main wash compartment

or in the appropriate com-

partment if the selected programme/option it requires

(see more details in "Detergent dispenser drawer").

If required, pour fabric softener into the compartment

marked

(the amount used must not exceed the

«MAX» mark in the drawer). Close the drawer gently.

Select the required programme by means of the

programme selector dial (1)

Turn the programme selector dial to the required pro-

gramme.

The green pilot light of button 7 starts to flash. The selec-

tor dial can be turned either clockwise or anticlockwise.

Turn the selector dial to position

to reset the pro-

gramme/to switch the machine OFF.

At the end of the programme the selector dial must be

turned to position

, to switch the machine off.

Important! If you turn the programme selector dial to

another programme when the machine is working, the red

pilot light of button 7 will blink 3 times and the

message

Err

is displayed to indicate a wrong selection.

The machine will not perform the new selected

programme.

Select the spin speed by pressing button 2

When selecting a programme, the appliance proposes au-

tomatically the maximum spin speed provided for that

programme. (See "Washing programmes" for the maxi-

mum allowed spin speed).

Press this button repeatedly to change the spin speed, if

you want your laundry to be spun at a different speed. The

relevant pilot light illuminates.

Select the available options by pressing the buttons

5 and 6

Depending on the programme, different options can be

combined. These must be selected after choosing the de-

sired programme and before starting the programme.

When these buttons are pressed, the corresponding pilot

lights illuminate. When they are pressed again, the pilot

lights go out. If an incorrect option is selected, the inte-

grated red pilot light of the button 7 flashes 3 times and

the message Err is displayed.

For the compatibility among the washing programmes and

the options see chapter «Washing programmes».

www.zanussi.com

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Zanussi ZWD1261 Manuel d'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Machines à laver Zanussi ZWD1261