Zanussi ZWD1261 Manuel d'utilisateur télécharger pdf (Page 16)

Note!

If possible, do not select a spin speed lower than

that proposed by the appliance to avoid too long a

drying time therefore saving energy.

In any case the reduction of the spin speed is only

possible after selecting drying.

5. Select the drying time by pressing the button 4 or

dryness degree by pressing the button 3. The display

shows the entire duration of the washing and the se-

lected drying cycle.

6. Start the programme by pressing button 7. After the

programme has started, the time remaining is upda-

ted every minute.

7. At the end of the programme the buzzer sounds. A

flashing zero «

» appear on the display. At this

point of the programme, starts an anti-crease phase

which lasts about 10 minutes. During this time the

door is locked and the display keeps showing the

flashing zero «

». (If you wish to open the door

before or during the anti-crease phase, please follow

the instructions given in the previous chapter).

Turn the selector dial to the

position to switch

the machine off.

9. Remove the laundry.

Fluff in the fabrics

During the WASHING AND/OR DRYING PHASE, certain

types of fabric, such as sponge, wool, sweatshirt, could

release fluff.

The released fluff could stick to the fabrics during the next

cycle.

This drawback increases with technical fabrics.

To prevent the fluff in your clothes, it is recommended:

• To do not wash dark fabrics after you washed and dried

light colored fabrics (new sponge, wool, sweatshirt es-

pecially) and vice versa.

• To air-dry this type of fabrics when they are washed the

first time.

• To clean the drain filter.

• After the drying phase, thoroughly clean the empty

drum, the gasket and the door with a wet rag.

To remove the fluff inside the drum, run a special pro-

gramme to clean it:

• Empty the drum and clean the drum, the gasket and the

door with a wet rag.

• Turn the programme selector to the rinse programme.

• Activate the cleaning function by pressing at the same

time button 5 and button 8 until the display shows

CLE.

• Press button 7 to start the programme.

Care and cleaning

Warning! You must DISCONNECT the appliance

from the electricity supply, before you can carry out

any cleaning or maintenance work.

Descaling

The water we use normally contains lime. It is a good idea

to periodically use a water softening powder in the ma-

chine. Do this separately from any laundry washing, and

according to the softening powder manufacturer's instruc-

tions. This will help to prevent the formation of lime de-

posits.

External cleaning

Clean the exterior cabinet of the appliance with soap and

water only, and then dry thoroughly.

Cleaning the dispenser drawer

The washing powder and additive dispenser drawer

should be cleaned regularly.

Remove the drawer by

pressing the catch down-

wards and by pulling it

out. Flush it out under a

tap, to remove any traces

of accumulated powder.

To aid cleaning, the top

part of the additive com-

partment should be re-

moved.

www.zanussi.com

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Zanussi ZWD1261 Manuel d'utilisateur Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Machines à laver Zanussi ZWD1261