Zanussi ZWD1261 Manuel d'utilisateur télécharger pdf (Page 25)

35°

45°

Open the porthole and extract the inlet hose.

Connect the hose with the angled connection to the ma-

chine. Do not place the inlet hose downwards. Angle

the hose to the left or right depending on the position of

your water tap.

Set the hose correctly by loosening the ring nut.

Connect the hose to a tap

with a 3/4” thread.

• After positioning the inlet hose, be sure to tighten

the ring nuts again to prevent leaks.

• The inlet hose must not be lengthened. If it is too

short and you do not wish to move the tap, you will

have to purchase a new, longer hose specially de-

signed for this type of use.

Water drainage

The end of the drain hose can be positioned in three ways:

Hooked over the edge of a

sink using the plastic hose

guide supplied with the

machine.

In this case, make sure the end cannot come unhooked

when the machine is emptying. This could be done by

tying it to the tap with a piece of string or attaching it to

the wall.

In a sink drain pipe branch. This branch must be above

the trap so that the bend is at least 60 cm above the

ground.

Directly into a drain pipe at a height of not less than 60

cm and not more than 90 cm. The end of the drain hose

must always be ventilated, i.e. the inside diameter of the

drain pipe must be larger than the outside diameter of

the drain hose. The drain hose must not be kinked.

Electrical connection

Information on the electrical connection is given on the

rating plate on the inner edge of the appliance door.

Check that your domestic electrical installation can take

the maximum load required, also taking into account any

other appliances in use.

Caution! Connect the machine to an earthed socket.

Caution! The manufacturer does not accept any

responsibility for damage or injury through failure

to comply with the above safety precaution.

Caution! The power supply cable must be easily

accessible after installing the machine.

Caution! Should the appliance power supply cable

need to be replaced, this must be carried out by a

Service Centre.

www.zanussi.com

1 2 ... 20 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire

Zanussi ZWD1261 Manuel d'utilisateur Page 25

Commentaires sur ces manuels

Produits connexes et manuels pour Machines à laver Zanussi ZWD1261