Zanussi ZCV65020WA Manuel d'utilisateur télécharger pdf (Page 24)

Location of the appliance

You can install your freestanding appliance with

cabinets on one or two sides and in the corner.

A

Minimum distances

Dimension mm

A 685

Levelling of the appliance

Use small feet on the bottom of appliance to set

the appliance top surface level with other

surfaces.

Anti-tilt protection

CAUTION!

Install the anti-tilt protection to

prevent the appliance from falling

under incorrect loads. The anti-tilt

protection only works when the

appliance is put in a correct area.

Your appliance has the symbols

shown on the pictures (if applicable)

to remind you about the installation

of the anti-tilt protection.

CAUTION!

Make sure you install the anti-tilt

protection at the correct height.

Make sure that the surface behind the appliance

is smooth.

1. Set the correct height and area for the

appliance before you attach the anti-tilt

protection.

2. Install the anti-tilt protection 176 mm down

from the top surface of the appliance and

24 mm from the left side of the appliance

into the circular hole on the bracket. See

the illustration. Screw it into the solid

material or use applicable reinforcement

(wall).

3. You can find the hole on the left side at the

back of the appliance. See the illustration.

Put the appliance in the middle of the space

between the cupboards (1). If the space

between the bench cupboards is larger

than the width of the appliance, you must

adjust the side measurement to centre the

appliance.

24 www.zanussi.com

1 2 ... 19 20 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire