Zanussi ZKG5030 Manuel d'utilisateur télécharger pdf (Page 30)

• Curtains must not be fitted immediately be-

hind the appliance or within 150mm of the

sides of the hotplate. If fitted next to or be-

tween two base units a minimum space of

1mm must be left between each unit and the

sides of the appliance. The hob must be set

to a minimum of 7mm above the adjacent

units. (Note: The levelling feet fitted to the

appliance will achieve a nominal height of

907mm -5+ 13mm. Base units not meeting

the above conditions must be a minimum of

100mm away from the hob.

min 150

min 7

min 1

750

max 400

• For appliances installed in the Republic of

Ireland please refer to NSAI-Domestic Gas

Installation IS813 Current Edition Section7

Permitted Locations of appliance Table4---

Locations and Permanent Ventilation re-

quirements-flueless appliances. Note: -

L.P.G. cookers MUST NOT be installed

below ground level i.e. in a basement or

aboard any boat, yacht or other vessel.

Levelling the appliance

• Adjustment to suit floor conditions or height

is obtained by rotating clockwise or anti

clockwise the feet at the front and rear of the

appliance. A spirit level should be placed on

one of the shelves to confirm the appliance

is correctly levelled.

Connecting to gas supply

• This appliance is designed to be installed

with an appliance flexible connection only.

• Supply piping should not be less than R3/8.

Connection is made to the Rc ½ (½" B.S.P)

female threaded entry pipe located just be-

low the hob level on the rear left hand side

of the appliance.

IMPORTANT!

Only liquid sealants to be used when inlet gas

pipe is fitted i.e.: do not use P.T.F.E. sealant

tape.

30

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

Commentaires sur ces manuels

Pas de commentaire